改善光纤倒像器的对比度传递特性

光纤倒像器是一种特殊类型的光纤板，可将传递图像直接倒转180°并应用于像增强器。由于光纤倒像器的特殊结构，造成光纤随着距扭转轴心的距离增加，数值孔径和光通量逐渐下降。相对于光纤板，光纤倒像器在透过率和对比度传递特性上均有一定程度的下降。通过改进玻璃系统，在一定程度上降低芯皮玻璃间离子扩散和相互渗透的程度，可提高光纤倒像器的实际数值孔径；通过调节EMA吸收量，既能满足像增强器对光纤倒像器荧光屏透过率的要求，又能保证最大程度地吸收光纤中逸出的杂散光，提高对比度。选择合理的芯皮比，不仅可弥补因扭转拉伸造成的皮层厚度减薄，还可进一步增加皮层厚度，抑制光从光纤中逸出。通过以上改进，可改善光纤倒像器的对比度传递特性。     

考虑到束-波相互作用的速调管离子噪声二维模拟

采用粒子模拟的方法并考虑电子束与电磁波的相互作用，首次直接得到了速调管输出信号的离子噪声图像，阐述了束电子、二次电子、离子、电磁场之间的相互作用的动力学过程. 指出离子噪声所表现出来的相位波动是由电子束速度的波动引起的，电子束速度的变化来源于管内离子数量的变化，离子的数量的变化又与电子束状态变化相互影响，这是离子噪声产生的根本原因. 二次电子对离子噪声产生过程的影响甚微，但是其行为却反映了离子噪声的形成机理. 离子噪声引发的输出信号幅度波动取决于电子束速度和半径的改变，与离子行为密切相关. 关键词： 离子噪声 速调管 粒子模拟 电子束     

Highly accurate calculation of radial spheroidal functions

A new method for calculating the radial spheroidal functions of the first kind is proposed for the arguments that are greater than unity in modulus. A well-known representation of these functions is refined and used for this purpose. The constructs and the software implementation proposed in the paper provide an efficient tool for the calculation of the functions with a desired accuracy in a wide range of parameters.     

Fundamental processes in long air gap discharges

The development of atmospheric lightning is initiated and sustained by the formation in virgin air of ‘streamer corona’ and ‘leader’ discharges, very similar to those observed in laboratory long sparks. Therefore, the experimental and theoretical investigations of these laboratory discharges have become of large interest to improve the physical knowledge of the lightning process and to develop self-consistent models that could be applied to new protection concepts.In the present paper the fundamental processes of the subsequent phases of long air gap discharges are analyzed, from the first corona inception and development to the leader channel formation and propagation. For all these processes simulations models are discussed that have been essentially derived and simplified by the authors, in order to develop sequential time-dependent simulation of the laboratory breakdown, with both positive and negative voltages. The possibility of extending these models to the case of natural lightning is discussed in the companion paper, presented in this same volume. To cite this article: I. Gallimberti et al., C. R. Physique 3 (2002) 1335–1359.     

在不同激光脉宽下的高次谐波

用数值计算方法计算了不同强激光脉冲宽度下高次谐波的产生.我们发现对于激光场强度不高,不能有效电离初态的激光场,长脉冲宽度可以更有效产生高次谐波;而对于高场强的激光场,由于它能够在几个光学周期之内把原子的初态全部电离,所以短脉冲的激光场能够更有效产生高次谐波.     

光码分多址系统中光学相关接收机判决阈值的分析

介绍了光码分多址系统中常用地址码（一维扩时码、二维码和三维码）的特点，并对它们各自的互相关均值和方差进行了理论分析。基于非相干光码分多址系统中光学相关接收机的基本原理，结合不同的用户地址码，对系统误码率性能进行了分析，得到了接收机最佳判决阈值与地址码基本特性参数和系统同时用户数间的关系。最后，给出了数值仿真结果。结果表明，对于采用特定地址码的光码分多址系统，只有选择合适的接收机判决阈值，系统的误码率性能才能达到最佳。研究结果对光码分多址系统中接收机判决阈值的选取具有一定的参考作用。     

Toward Fuzzy Optimization without Mathematical Ambiguity

Fuzzy programming has been discussed widely in literature and applied in such various disciplines as operations research, economic management, business administration, and engineering. The main purpose of this paper is to present a brief review on fuzzy programming models, and classify them into three broad classes: expected value model, chance-constrained programming and dependent-chance programming. In order to solve general fuzzy programming models, a hybrid intelligent algorithm is also documented. Finally, some related topics are discussed.     

场协同理论在椭圆型流动中的数值验证

本文用数值模拟的方法，通过四个椭圆型流动传热的例子验证了场协同理论的正确性．结果表明，场协同理论不仅适合于抛物型流动，亦适合于复杂的有回流的椭圆型流动．     

机翼大攻角下失速颤振的气动弹性研究

本文采用流固耦合的数值方法研究了机翼在0°～50°攻角下的颤振。计算结果表明,随着来流攻角α0的增大,机翼的固有频率对颤振的影响越来越大,颤振由线性的强迫振动逐渐发展成为非线性的自激振动,而当α0增加到一定程度以后,大尺度分离流交替地从机翼头部和尾部产生,机翼和流场会发生共振,引起机翼的失速颤振。     

1+1/2对转涡轮叶排轴向间距对性能影响的研究

木文对1+1/2对转涡轮中轴向间距影响进行了初步研究。对不同轴向间距叶栅流场进行了大量时间精确模拟。研究表明,1+1/2对转涡轮高低压转叶间轴向间距成为追求高效率的制约因素,轴向间距为高压转叶喉部宽度是关键点。因此有关小轴向间距下强激波/叶排干扰的研究应该加强。